The Best Wear Rods for Arctic Cat Snowmobiles
Uncertain about which Arctic Cat wear rod you have? Match the dimensions and bolt pattern of your existing wear rod to the drawings below.Â
Choose the wear rod that’s best for you
Arctic Cat Wear Rod Drawings
The B- number to the left of the drawing is the Bergstrom Skegs model number.
NOTE: Not every wear rod we make may be shown below.     Red = Carbide bolt pattern
B11-A Note:Â We don’t put a 90 degree bend at the front of the wear rod because we don’t believe you should have to use a hammer to install wear rods. Â Also, if the bend is not absolutely perfect, you would have to grind the rod to make it fit. Â We do cover enough of the hole, so snow will not come through it.
B11-B Note: We don’t put a 90 degree bend at the front of the wear rod because we don’t believe you should have to use a hammer to install wear rods. Also, if the bend is not absolutely perfect, you would have to grind the rod to make it fit. We do cover enough of the hole, so snow will not come through it.
These factory wear rods’ front bend does not fit into the ski because it is not on the same plane as the bolt. The 3/8″ bolts are difficult to install into the 3/8″ holes in the ski.
Also, the factory rod bolt spacing was incorrect.
Â
